Help with 48-482

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Help with 48-482

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

09-03-2018, 08:37 PM

I'm missing something too. If you apply a rf signal to the volume control you shouldn't hear it. The rf signal must be rectified to covert it to an audio signal. If you want the use rf @ 455kc connect it to the control grid of the 7H7 (p6 I think). Make sure your mode switch is good and clean.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

(This post was last modified: 09-03-2018, 08:38 PM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Help with 48-482 - by Patrick - 09-03-2018, 10:08 AM

RE: Help with 48-482 - by morzh - 09-03-2018, 05:07 PM

RE: Help with 48-482 - by Patrick - 09-03-2018, 05:18 PM

RE: Help with 48-482 - by morzh - 09-03-2018, 05:23 PM

RE: Help with 48-482 - by Patrick - 09-03-2018, 05:37 PM

RE: Help with 48-482 - by Radioroslyn - 09-03-2018, 08:37 PM

RE: Help with 48-482 - by morzh - 09-03-2018, 08:59 PM

RE: Help with 48-482 - by Patrick - 09-03-2018, 09:23 PM

RE: Help with 48-482 - by Patrick - 09-03-2018, 09:25 PM

RE: Help with 48-482 - by mikethedruid - 09-04-2018, 01:40 AM

RE: Help with 48-482 - by Patrick - 09-04-2018, 05:46 AM

RE: Help with 48-482 - by morzh - 09-04-2018, 08:46 AM

RE: Help with 48-482 - by Patrick - 09-04-2018, 12:42 PM

RE: Help with 48-482 - by Patrick - 09-07-2018, 07:38 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 4998 online users. [Complete List]
» 2 Member(s) | 4996 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me