Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89L-troubles
#18

There's only a couple of things it might effect if in is too high. One would be the avc voltage/timing but since it's Am we are receiving it's going to be pretty negotiable. Would raise the gain of the 1st audio state. Again not a big deal. And may not track well ( all the control at one end of the turning radius). Other than that your home free!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 89L-troubles - by vecher - 04-30-2018, 08:41 PM
RE: Philco 89L - by KCMike - 04-30-2018, 09:02 PM
RE: Philco 89L - by Chas - 05-02-2018, 08:27 PM
RE: Philco 89L - by vecher - 06-24-2018, 11:07 AM
RE: Philco 89L - by Radioroslyn - 06-24-2018, 11:49 AM
RE: Philco 89L - by vecher - 06-24-2018, 02:01 PM
RE: Philco 89L - by Radioroslyn - 06-24-2018, 02:57 PM
RE: Philco 89L - by vecher - 06-24-2018, 04:17 PM
RE: Philco 89L - by vecher - 08-03-2018, 11:28 PM
RE: Philco 89L - by Chas - 08-04-2018, 10:44 AM
RE: Philco 89L - by radio63 - 08-14-2018, 08:12 PM
RE: Philco 89L - by Chas - 08-14-2018, 09:39 PM
RE: Philco 89L - by radio63 - 08-15-2018, 03:23 PM
RE: Philco 89L - by jcassity - 08-18-2018, 10:55 AM
RE: Philco 89L - by vecher - 09-09-2018, 12:22 AM
RE: Philco 89L - by Radioroslyn - 09-09-2018, 01:00 AM
RE: Philco 89L - by vecher - 09-09-2018, 04:30 PM
RE: Philco 89L - by Radioroslyn - 09-09-2018, 06:28 PM
RE: Philco 89L - by vecher - 09-09-2018, 11:43 PM
RE: Philco 89L - by morzh - 09-10-2018, 08:37 AM
RE: Philco 89L-Problems - by vecher - 10-17-2018, 05:04 PM
RE: Philco 89L-troubles - by KCMike - 10-17-2018, 05:13 PM
RE: Philco 89L-troubles - by Radioroslyn - 10-17-2018, 05:51 PM
RE: Philco 89L-troubles - by Steve Davis - 10-17-2018, 06:53 PM
RE: Philco 89L-troubles - by vecher - 10-17-2018, 09:09 PM
RE: Philco 89L-troubles - by vecher - 10-17-2018, 10:49 PM
RE: Philco 89L-troubles - by Radioroslyn - 10-17-2018, 11:08 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 12:01 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 03:16 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 08:24 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 11:09 PM
RE: Philco 89L-troubles - by Arran - 10-19-2018, 03:12 AM
RE: Philco 89L-troubles - by vecher - 10-19-2018, 01:08 PM
RE: Philco 89L-troubles - by klondike98 - 10-19-2018, 01:13 PM
RE: Philco 89L-troubles - by vecher - 10-19-2018, 02:07 PM
RE: Philco 89L-troubles - by vecher - 10-21-2018, 11:35 PM
RE: Philco 89L-troubles - by vecher - 10-22-2018, 09:17 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Restore Code ??
Can someone tell me if my 42 tubes are connected triode or pentode in fixed or cathode bias? How could I tell by looking...dconant — 10:47 AM
Philco 40-120C Restoration
Hello David, that is great news about the tubes source being local ! Sounds like you got good start on the radio . ...radiorich — 09:41 AM
An attempt to remove the Field Coil from a G speaker
Mike; I've only run into a speaker with an open filed coil twice, and they were on newer speakers from the 1940s. One ...Arran — 12:48 AM
An attempt to remove the Field Coil from a G speaker
Arran Yes, this is my plan for now and what do I got to lose, this is not even the speaker from this radio, but one o...morzh — 10:44 PM
An attempt to remove the Field Coil from a G speaker
Mike;  I would unwrap the field coil, and see if maybe there a break near one of the ends, like where the coil wire att...Arran — 10:23 PM
An attempt to remove the Field Coil from a G speaker
...and this is what I did. I fed a little LT into the screwholes with a small brush, and a little on the rim next to the...morzh — 09:52 PM
Philco 40-120C Restoration
I combined the two 40-120C threads together as we like to keep the discussion of the same radio together. It helps with...klondike98 — 09:36 PM
Philco 40-120C Weak, Distorted Ouput
Just checked were I buy tubes price is four dollars. So living in Florid we have a local source for tubes. David    David — 09:14 PM
Philco 40-120C Weak, Distorted Ouput
The higher voltage may be due to higher mains voltage. My mains run 120-125AC when the set was new mains would be 110-11...David — 09:09 PM
Philco 40-120C Weak, Distorted Ouput
Thank you for your reply. I pulled a speaker from a Philco 41-221 and received the same result. I used a signal tracer t...bluecap — 08:45 PM

[-]
Who's Online
There are currently 2833 online users. [Complete List]
» 2 Member(s) | 2831 Guest(s)
AvatarAvatar

>