Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89L-troubles
#36

Ok Everything was working fine..But now the OSC died.. I tried numerous 36 tubes all do not work now.. Even the one that did doesn't Oscillate now.. I was subbing tubes to see if I could get the low end of band to work better..

I hope Osc coil didn't open? I will check that tomorrow.. Then if OK.. Then Now what???

Skip


Messages In This Thread
Philco 89L-troubles - by vecher - 04-30-2018, 08:41 PM
RE: Philco 89L - by KCMike - 04-30-2018, 09:02 PM
RE: Philco 89L - by Chas - 05-02-2018, 08:27 PM
RE: Philco 89L - by vecher - 06-24-2018, 11:07 AM
RE: Philco 89L - by Radioroslyn - 06-24-2018, 11:49 AM
RE: Philco 89L - by vecher - 06-24-2018, 02:01 PM
RE: Philco 89L - by Radioroslyn - 06-24-2018, 02:57 PM
RE: Philco 89L - by vecher - 06-24-2018, 04:17 PM
RE: Philco 89L - by vecher - 08-03-2018, 11:28 PM
RE: Philco 89L - by Chas - 08-04-2018, 10:44 AM
RE: Philco 89L - by radio63 - 08-14-2018, 08:12 PM
RE: Philco 89L - by Chas - 08-14-2018, 09:39 PM
RE: Philco 89L - by radio63 - 08-15-2018, 03:23 PM
RE: Philco 89L - by jcassity - 08-18-2018, 10:55 AM
RE: Philco 89L - by vecher - 09-09-2018, 12:22 AM
RE: Philco 89L - by Radioroslyn - 09-09-2018, 01:00 AM
RE: Philco 89L - by vecher - 09-09-2018, 04:30 PM
RE: Philco 89L - by Radioroslyn - 09-09-2018, 06:28 PM
RE: Philco 89L - by vecher - 09-09-2018, 11:43 PM
RE: Philco 89L - by morzh - 09-10-2018, 08:37 AM
RE: Philco 89L-Problems - by vecher - 10-17-2018, 05:04 PM
RE: Philco 89L-troubles - by KCMike - 10-17-2018, 05:13 PM
RE: Philco 89L-troubles - by Radioroslyn - 10-17-2018, 05:51 PM
RE: Philco 89L-troubles - by Steve Davis - 10-17-2018, 06:53 PM
RE: Philco 89L-troubles - by vecher - 10-17-2018, 09:09 PM
RE: Philco 89L-troubles - by vecher - 10-17-2018, 10:49 PM
RE: Philco 89L-troubles - by Radioroslyn - 10-17-2018, 11:08 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 12:01 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 03:16 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 08:24 PM
RE: Philco 89L-troubles - by vecher - 10-18-2018, 11:09 PM
RE: Philco 89L-troubles - by Arran - 10-19-2018, 03:12 AM
RE: Philco 89L-troubles - by vecher - 10-19-2018, 01:08 PM
RE: Philco 89L-troubles - by klondike98 - 10-19-2018, 01:13 PM
RE: Philco 89L-troubles - by vecher - 10-19-2018, 02:07 PM
RE: Philco 89L-troubles - by vecher - 10-21-2018, 11:35 PM
RE: Philco 89L-troubles - by vecher - 10-22-2018, 09:17 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM
Zenith H725
I think the problem is traced - to noise on the AC line. It sounded so local, that it seemed certain it was generated wi...EdHolland — 05:51 PM
The list of my radio & TV collection!
A little bit of positivity in our feed... My new video... Test - the Philco 16B vs Philco 37-116 de Luxe / Test - the ...RadioSvit — 12:14 PM
Refinishing Ideas
Thanks. I will look into. Billpoulsbobill — 11:23 AM
My Philco 37-116 Restore
Why do the flood lights have 2 wires running to the shell of each light when the inner conductor only has one to each? ...dconant — 10:54 AM
Philco 46-480 Electronic Restoration
OOPS!! if there is a "flag" running up the side of the tube that touches the shield, then yes, a shield belon...MrFixr55 — 10:03 AM
Philco 46-480 Electronic Restoration
Thanks for pointing out that shield! I will try to find out where else it may belong. I simply installed it back where i...jrblasde — 10:02 AM
Philco 46-480 Electronic Restoration
Very nice job. A real contrast between how easy the main chassis is to work on, vs how tightly the RF chassis is packed...MrFixr55 — 09:31 AM

[-]
Who's Online
There are currently 604 online users. [Complete List]
» 3 Member(s) | 601 Guest(s)
AvatarAvatarAvatar

>