1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
40-158 Veneer question- Updated-Finished!
Greggshere
Member
***
Posts: 189
Threads: 22
Joined: Aug 2018
City: Kewanee State, Province, Country: Illinois
#25

10-31-2018, 11:07 PM
Thank you PhilcoJohn!! It was my first complete restoration for both electrical and cabinet. I learned a lot and hope each time the next one is better than the previous.
1929 Victor R-32, 1933 60L, Phil 40-158, Phil 42-400X, Phil 47-1230 Radio/Phono,, 1950 Phil TV t-1104, Air King 4000, Philco 41-105, Philco 37-675, RCA Victor 9K2, PT-50, Phil 54C, PT-44 Cabinet, Phil 118X Cabinet

Gregg Icon_thumbup
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: 40-158 Veneer question - by Radioroslyn - 09-01-2018, 09:38 PM
RE: 40-158 Veneer question - by Greggshere - 09-01-2018, 09:53 PM
RE: 40-158 Veneer question - by Radioroslyn - 09-01-2018, 10:16 PM
RE: 40-158 Veneer question - by Greggshere - 09-01-2018, 10:41 PM
RE: 40-158 Veneer question - by Greggshere - 10-07-2018, 11:41 PM
RE: 40-158 Veneer question - by DadsRadio - 10-13-2018, 09:40 AM
RE: 40-158 Veneer question - by klondike98 - 10-13-2018, 07:18 PM
RE: 40-158 Veneer question - by DadsRadio - 10-15-2018, 07:29 PM
RE: 40-158 Veneer question - by Radioroslyn - 10-16-2018, 11:46 PM
RE: 40-158 Veneer question - by Greggshere - 10-17-2018, 12:19 AM
RE: 40-158 Veneer question - by Ron Ramirez - 10-17-2018, 05:56 AM
RE: 40-158 Veneer question - by Greggshere - 10-17-2018, 10:52 AM
RE: 40-158 Veneer question - by Ron Ramirez - 10-17-2018, 11:44 AM
RE: 40-158 Veneer question - by Greggshere - 10-17-2018, 12:51 PM
RE: 40-158 Veneer question - by Greggshere - 10-21-2018, 12:04 AM
RE: 40-158 Veneer question - by klondike98 - 10-21-2018, 09:32 AM
RE: 40-158 Veneer question - by DadsRadio - 10-25-2018, 01:57 PM
RE: 40-158 Veneer question - by Greggshere - 10-26-2018, 05:03 PM
RE: 40-158 Veneer question- Updated-Finished! - by Greggshere - 10-31-2018, 11:07 PM



Users browsing this thread: 13 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6921 online users. [Complete List]
» 1 Member(s) | 6920 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration