Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 6-S-147 Chairside
#7

I'm not 100% certain but I think that Oriental Walnut and Australian Walnut are just different names for the same species of tree, which grows in Queensland. though in that last photo it does look a lot like Australian Walnut. I've also heard another name of "Orientalwood" in some cabinet descriptions from back then, but it may just be a marketing name.
Regards
Arran


Messages In This Thread
Zenith 6-S-147 Chairside - by Patrick - 10-28-2018, 04:33 PM
RE: Zenith 6-S-147 Chairside - by Phlogiston - 10-28-2018, 07:37 PM
RE: Zenith 6-S-147 Chairside - by Patrick - 10-28-2018, 08:40 PM
RE: Zenith 6-S-147 Chairside - by Phlogiston - 10-28-2018, 09:18 PM
RE: Zenith 6-S-147 Chairside - by Arran - 10-29-2018, 03:55 AM
RE: Zenith 6-S-147 Chairside - by Patrick - 10-29-2018, 05:44 AM
RE: Zenith 6-S-147 Chairside - by Arran - 11-01-2018, 12:11 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>