Philco 40-180 Output Transformer 32-8053 Replacement

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 40-180 Output Transformer 32-8053 Replacement

glwells
Junior Member

Posts: 15
Threads: 5
Joined: Aug 2009
City: Columbus State, Province, Country: NC

10-05-2010, 09:26 AM

Thanks Ron. I ordered the Hammond 125E from Radiodaze so we will see how it works. I will set it up for about a 12k impedance for the 41's. Now I have to figure out the tone control as I am confused by the 6meg/400k description on the schematic! I hope both pots are ok after I clean them up since I don't find audio tapers with a 1 meg tap around. Thanks again for the help.

Gary
WB9AYD

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 40-180 Output Transformer 32-8053 Replacement - by glwells - 10-02-2010, 05:21 PM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by John R - 10-02-2010, 09:54 PM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by glwells - 10-03-2010, 12:58 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by Ron Ramirez - 10-03-2010, 07:53 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by glwells - 10-05-2010, 09:26 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by Chuck Schwark - 10-05-2010, 09:40 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by glwells - 10-05-2010, 09:56 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by Ron Ramirez - 10-05-2010, 10:16 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by glwells - 10-05-2010, 11:26 AM

Re: Philco 40-180 Output Transformer 32-8053 Replacement - by Chuck Schwark - 10-05-2010, 11:57 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5006 online users. [Complete List]
» 1 Member(s) | 5005 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me