Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-200 Grill Cloth
#4

I'm not familiar with 99, but - probably. Just don't go overboard with spraying the stuff on. Do it outdoors if possible, in a garage with nothing around that you don't want to get the stuff on otherwise - and WEAR A MASK OR (preferably) RESPIRATOR.

Oh, and don't use it in cold weather. Don't ask how I know that. The ambient temperature should be above 60 degrees, warmer is better.

The hard part is geting the cloth on after spraying the cement. You can work with Super 77 for a short period of time, but it is very tricky to get the cloth stretched just right. I still don't have the "knack" of doing it perfectly.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco 40-200 Grill Cloth - by drrenaud - 12-06-2018, 11:43 AM
RE: Philco 40-200 Grill Cloth - by Ron Ramirez - 12-06-2018, 01:03 PM
RE: Philco 40-200 Grill Cloth - by drrenaud - 12-06-2018, 01:53 PM
RE: Philco 40-200 Grill Cloth - by Ron Ramirez - 12-06-2018, 01:59 PM
RE: Philco 40-200 Grill Cloth - by Patrick - 12-06-2018, 10:24 PM
RE: Philco 40-200 Grill Cloth - by Ron Ramirez - 12-06-2018, 10:25 PM
RE: Philco 40-200 Grill Cloth - by Patrick - 12-06-2018, 10:35 PM
RE: Philco 40-200 Grill Cloth - by Arran - 12-07-2018, 01:15 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 7856 online users. [Complete List]
» 1 Member(s) | 7855 Guest(s)
Avatar

>