Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-200 Grill Cloth
#7

I think I'm going to try some 77 since you said you can work with it for a small amount of time. Once 99 makes contact, it's really hard to do anything with it. I started using it before I found the trick of wetting the cloth, because it would hold fast, and I just never tried anything else. Thanks, Ron.

Oh, and Spotnails stock #87002 staples are only 1/8". They're also great for the occasional plastic dial cover. You just have to reduce the air down to about 30psi or they'll go right through the plastic.


Messages In This Thread
Philco 40-200 Grill Cloth - by drrenaud - 12-06-2018, 11:43 AM
RE: Philco 40-200 Grill Cloth - by Ron Ramirez - 12-06-2018, 01:03 PM
RE: Philco 40-200 Grill Cloth - by drrenaud - 12-06-2018, 01:53 PM
RE: Philco 40-200 Grill Cloth - by Ron Ramirez - 12-06-2018, 01:59 PM
RE: Philco 40-200 Grill Cloth - by Patrick - 12-06-2018, 10:24 PM
RE: Philco 40-200 Grill Cloth - by Ron Ramirez - 12-06-2018, 10:25 PM
RE: Philco 40-200 Grill Cloth - by Patrick - 12-06-2018, 10:35 PM
RE: Philco 40-200 Grill Cloth - by Arran - 12-07-2018, 01:15 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 6126 online users. [Complete List]
» 1 Member(s) | 6125 Guest(s)
Avatar

>