Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 95 multi-section caps
#9

Thanks!!  That really helps.


Messages In This Thread
Model 95 multi-section caps - by rrbark - 11-30-2018, 09:58 PM
RE: Model 95 multi-section caps - by klondike98 - 11-30-2018, 10:27 PM
RE: Model 95 multi-section caps - by morzh - 11-30-2018, 10:31 PM
RE: Model 95 multi-section caps - by Radioroslyn - 12-01-2018, 12:03 AM
RE: Model 95 multi-section caps - by morzh - 12-01-2018, 12:19 AM
RE: Model 95 multi-section caps - by rrbark - 12-05-2018, 09:36 PM
RE: Model 95 multi-section caps - by Radioroslyn - 12-05-2018, 10:24 PM
RE: Model 95 multi-section caps - by Arran - 12-07-2018, 12:39 AM
RE: Model 95 multi-section caps - by rrbark - 12-08-2018, 12:21 PM
RE: Model 95 multi-section caps - by rrbark - 12-08-2018, 12:22 PM
RE: Model 95 multi-section caps - by 462ron - 12-09-2018, 11:11 AM
RE: Model 95 multi-section caps - by morzh - 12-09-2018, 12:15 PM
RE: Model 95 multi-section caps - by amptramp - 12-09-2018, 03:08 PM
RE: Model 95 multi-section caps - by 462ron - 12-10-2018, 09:32 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>