12-19-2018, 10:15 AM
will do but first
i have to warm up the set till it starts to fail.
i want to kill that noise but still have the set failing to take test point measurements... so can i put a 3 ohm resistor in place of the speaker? or can it continue its free fall without a speaker attached?
i know in the past you've said its not good to power some of these sets up without a speaker.
is it risky to keep it powered on while its failing?
i have to warm up the set till it starts to fail.
i want to kill that noise but still have the set failing to take test point measurements... so can i put a 3 ohm resistor in place of the speaker? or can it continue its free fall without a speaker attached?
i know in the past you've said its not good to power some of these sets up without a speaker.
is it risky to keep it powered on while its failing?