Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

An RCA 140
#13

And beware the power transformers in these sets. Seems like the radios I run into with this chassis around my area always seem to have dead transformers. That and they are a bear to rebuild with the way they are built. Actually, I should have left mine sit a bit longer before taking it up to be rebuilt. I need to get my butt in gear now and get a transformer for it.

No matter where you go, there you are.


Messages In This Thread
An RCA 140 - by exray - 09-28-2010, 08:41 PM
Re: An RCA 140 - by exray - 09-28-2010, 08:46 PM
Re: An RCA 140 - by Ron Ramirez - 09-28-2010, 08:58 PM
Re: An RCA 140 - by exray - 09-28-2010, 09:37 PM
Re: An RCA 140 - by Alan Douglas - 09-29-2010, 06:34 PM
Re: An RCA 140 - by denver - 09-29-2010, 07:53 PM
Re: An RCA 140 - by Jayce - 09-29-2010, 11:17 PM
Re: An RCA 140 - by exray - 09-30-2010, 09:46 PM
Re: An RCA 140 - by Jayce - 10-02-2010, 09:07 PM
Re: An RCA 140 - by Ken G - 10-11-2010, 08:05 PM
Re: An RCA 140 - by Allen in SB - 10-17-2010, 12:51 AM
Re: An RCA 140 - by exray - 10-17-2010, 07:07 AM
Re: An RCA 140 - by Jayce - 10-17-2010, 05:15 PM
Re: An RCA 140 - by Doug Houston - 11-23-2010, 01:30 AM
Re: An RCA 140 - by Jayce - 11-23-2010, 06:06 PM
Re: An RCA 140 - by exray - 11-24-2010, 08:19 AM
Re: An RCA 140 - by Jayce - 11-29-2010, 06:27 PM
Re: An RCA 140 - by FStephenMasek - 12-01-2010, 11:48 PM
Re: An RCA 140 - by Jayce - 12-02-2010, 03:38 PM
Re: An RCA 140 - by exray - 12-02-2010, 04:40 PM
Re: An RCA 140 - by Ron Ramirez - 12-03-2010, 12:18 AM
Re: An RCA 140 - by TA Forbes - 12-09-2010, 09:07 PM
Re: An RCA 140 - by Doug Houston - 01-01-2011, 08:44 PM
Re: An RCA 140 - by theboyzz - 01-29-2011, 12:14 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 2489 online users. [Complete List]
» 3 Member(s) | 2486 Guest(s)
AvatarAvatarAvatar

>