Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 39-25T
#5

(01-02-2019, 10:46 AM)klondike98 Wrote:  Radio Daze makes the white and black dial reproduction.  Same dial is used on the 39-30 and 39-25.

There is a metal escutcheon that goes over the top of the area for the dial.  The escutcheon holds the station labels in some slots.  New buttons are available from Renovated Radios.




Here's the best close up of the escutcheon I have:
[Image: https://www.dropbox.com/s/zs4gzs6la1aohd....jpg?raw=1]

The escutcheon is not reproduced so you will have to find one on a donor chassis.  Perhaps an ad in the wanted section here and keep an eye on the ebay offerings.  


some notes and threads on the restoration can be found in the link in the signature below


That escutcheon color look right, but I have seen some that seem to be nickel plated as well (dull silver).

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
Philco 39-25T - by Chris h - 01-01-2019, 11:47 PM
RE: Philco 39-25T - by klondike98 - 01-02-2019, 10:46 AM
RE: Philco 39-25T - by Nathan Slingerland - 01-02-2019, 10:59 AM
RE: Philco 39-25T - by klondike98 - 01-02-2019, 11:59 AM
RE: Philco 39-25T - by Phlogiston - 01-02-2019, 01:59 PM
RE: Philco 39-25T - by Chris h - 01-02-2019, 11:57 PM
RE: Philco 39-25T - by Nathan Slingerland - 01-03-2019, 12:14 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4958 online users. [Complete List]
» 2 Member(s) | 4956 Guest(s)
AvatarAvatar

>