Problems in a little PT2

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Problems in a little PT2

elfiself
Member

Posts: 58
Threads: 9
Joined: Apr 2016
City: Albany,NY

01-03-2019, 02:11 PM

lets start with 56.6k ohm value for secondary of 2nd IF transformer measured between 7C6 pin 5 (d1) and high side of volume control.
next I replaced the 40/80 ohm line resistor with 10w wire wounds. in the circuit the 40 measures good while the 80 measures 3.7 ohms.
thoughts please
Larry

Find

« Next Oldest | Next Newest »

Messages In This Thread

PT2 tuning capacitor - by elfiself - 01-02-2019, 10:47 PM

RE: Problems in a little PT2 - by Ron Ramirez - 01-03-2019, 03:54 PM

RE: Problems in a little PT2 - by elfiself - 01-04-2019, 03:45 PM

RE: Problems in a little PT2 - by Radioroslyn - 01-04-2019, 04:20 PM

RE: Problems in a little PT2 - by elfiself - 01-04-2019, 05:06 PM

RE: PT2 tuning capacitor - by gregb - 01-02-2019, 10:50 PM

RE: PT2 tuning capacitor - by elfiself - 01-02-2019, 11:26 PM

problems in a little PT2 - by elfiself - 01-03-2019, 02:11 PM

RE: PT2 tuning capacitor - by Radioroslyn - 01-03-2019, 02:49 PM

RE: PT2 tuning capacitor - by sam - 01-03-2019, 02:49 PM

Problems in a little PT2 - by elfiself - 01-03-2019, 03:49 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5099 online users. [Complete List]
» 1 Member(s) | 5098 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me