Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What are your opinions on a Model 650 Console
#1

I have spotted a 650 console in pretty decent shape. The only reason it's not mine already is that is it 250 miles away from me. Meaning it would be a 500 mile round trip, and take an all day drive, and traveling over a mountain pass. The guy is holding it for a day or two, so I can make up my mind. I can get it for $70, plus the gas it will take to make the trip.

I like the looks of the cabinet, and according to the seller, it works just fine. (you know how that can go).

What are your opinions of the model?

Desirable?

Too common?

Not common?

Do they sound good?

Thanks for any advice you can give me.

It looks like this one.  Not this exact one, but this model. 

[Image: https://i.imgur.com/oS3rK4W.jpg?1]


Messages In This Thread
What are your opinions on a Model 650 Console - by rdnzl - 01-03-2019, 07:11 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5163 online users. [Complete List]
» 1 Member(s) | 5162 Guest(s)
Avatar

>