Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Nathan's 38-116XX Restoration
#12

+1!
Tnx for the tip on the brown glue. I had looked around for some awhile back but it's was kinda pricey and didn't like the available colors. Just ordered 36 sticks for abt $7.

I did a 37-116 122 back in the mid '80s (the radio not me) didn't remove the sub chassis but got most of the caps replaced. The set worked well for several years but eventually it died. Turned out to be an unreplaced cap the the oscillator circuit has shorted. Was able to get it out with out a lot of disassembly and was restored to operating condition. Years later one of the filter went leaky and I haven't gotten around to having a look at it.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
RE: Nathan's 38-116XX Restoration - by klondike98 - 01-04-2019, 12:04 AM
RE: Nathan's 38-116XX Restoration - by rfeenstra - 01-04-2019, 12:12 AM
RE: Nathan's 38-116XX Restoration - by sam - 01-05-2019, 09:15 PM
RE: Nathan's 38-116XX Restoration - by klondike98 - 01-05-2019, 11:29 PM
RE: Nathan's 38-116XX Restoration - by Radioroslyn - 01-06-2019, 12:41 AM
RE: Nathan's 38-116XX Restoration - by 462ron - 01-07-2019, 09:06 AM
RE: Nathan's 38-116XX Restoration - by Jeremy S - 01-07-2019, 04:46 PM
RE: Nathan's 38-116XX Restoration - by rfeenstra - 01-08-2019, 12:04 AM
RE: Nathan's 38-116XX Restoration - by rfeenstra - 01-10-2019, 12:42 AM
RE: Nathan's 38-116XX Restoration - by amptramp - 01-10-2019, 10:21 PM
RE: Nathan's 38-116XX Restoration - by sam - 01-11-2019, 12:23 PM
RE: Nathan's 38-116XX Restoration - by tbone - 01-12-2019, 07:48 AM
RE: Nathan's 38-116XX Restoration - by klondike98 - 01-18-2019, 10:19 AM
RE: Nathan's 38-116XX Restoration - by EdHolland - 01-18-2019, 02:41 PM
RE: Nathan's 38-116XX Restoration - by rfeenstra - 01-19-2019, 01:46 PM
RE: Nathan's 38-116XX Restoration - by rfeenstra - 02-17-2019, 04:25 PM
RE: Nathan's 38-116XX Restoration - by rfeenstra - 02-17-2019, 05:15 PM
RE: Nathan's 38-116XX Restoration - by klondike98 - 02-17-2019, 05:33 PM
RE: Nathan's 38-116XX Restoration - by morzh - 02-17-2019, 05:38 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 6285 online users. [Complete List]
» 1 Member(s) | 6284 Guest(s)
Avatar

>