Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-1008 code 121
#21

What kind of voltage should i be seeing out of the output transformer?


Messages In This Thread
42-1008 code 121 - by rperry - 01-12-2019, 09:01 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-12-2019, 09:21 PM
RE: 42-1008 code 121 - by rperry - 01-12-2019, 09:44 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-12-2019, 10:08 PM
RE: 42-1008 code 121 - by rperry - 01-12-2019, 10:13 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-12-2019, 10:28 PM
RE: 42-1008 code 121 - by rperry - 01-12-2019, 10:59 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-12-2019, 11:19 PM
RE: 42-1008 code 121 - by rperry - 01-12-2019, 11:40 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-13-2019, 12:24 AM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 06:07 PM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 06:11 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-13-2019, 06:15 PM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 06:44 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-13-2019, 06:51 PM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 07:03 PM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 07:15 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-13-2019, 07:19 PM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 07:29 PM
RE: 42-1008 code 121 - by rperry - 01-13-2019, 07:51 PM
RE: 42-1008 code 121 - by rperry - 01-14-2019, 12:25 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-14-2019, 01:36 PM
RE: 42-1008 code 121 - by rperry - 01-14-2019, 02:35 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-14-2019, 04:36 PM
RE: 42-1008 code 121 - by rperry - 01-14-2019, 05:21 PM
RE: 42-1008 code 121 - by Radioroslyn - 01-14-2019, 05:25 PM
RE: 42-1008 code 121 - by rperry - 01-15-2019, 09:04 PM
RE: 42-1008 code 121 - by rperry - 01-18-2019, 06:09 PM
RE: 42-1008 code 121 - by rperry - 01-20-2019, 11:24 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently 5845 online users. [Complete List]
» 1 Member(s) | 5844 Guest(s)
Avatar

>