Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Re-Stuff, I MEANT RE-Stuff!
#1

https://www.russoldradios.com/blog
 
Icon_rolleyes Icon_twisted

Easier the second time - -

bad russ

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
Re-Stuff, I MEANT RE-Stuff! - by Phlogiston - 01-25-2019, 04:07 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by jcassity - 01-25-2019, 05:37 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by morzh - 01-25-2019, 06:36 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by Phlogiston - 01-25-2019, 07:21 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by Arran - 01-26-2019, 06:20 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by morzh - 01-26-2019, 07:14 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by Phlogiston - 01-26-2019, 07:44 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by TV MAN - 01-30-2019, 12:47 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by Phlogiston - 01-30-2019, 07:49 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by KCMike - 01-30-2019, 08:19 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by Phlogiston - 01-30-2019, 08:45 PM
RE: Re-Stuff, I MEANT RE-Stuff! - by TV MAN - 02-01-2019, 10:28 AM
RE: Re-Stuff, I MEANT RE-Stuff! - by Phlogiston - 02-01-2019, 03:37 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM
Zenith H725
I think the problem is traced - to noise on the AC line. It sounded so local, that it seemed certain it was generated wi...EdHolland — 05:51 PM
The list of my radio & TV collection!
A little bit of positivity in our feed... My new video... Test - the Philco 16B vs Philco 37-116 de Luxe / Test - the ...RadioSvit — 12:14 PM
Refinishing Ideas
Thanks. I will look into. Billpoulsbobill — 11:23 AM

[-]
Who's Online
There are currently 274 online users. [Complete List]
» 4 Member(s) | 270 Guest(s)
AvatarAvatarAvatarAvatar

>