Zenith R600 TO garbled reception

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Zenith R600 TO garbled reception

OZ4
Senior Member

Posts: 285
Threads: 27
Joined: Nov 2012
City: Tehachapi. California

01-30-2019, 11:15 PM

After thinking about it some if the broadcast band sounds good then the IF, Detector and Audio section is good. Look to the RF front end section for the suspect items. The parts that switch in for SW.

!!!!!!!!!!!!!!!!!!!RESISTANCE IS FUTILE!!!!!!!!!!!!!!!!!!!!!!
/\/\/\/\/\/\/\/\/\

     [Image: http://philcoradio.com/phorum/images/smi...on_eek.gif] Chris

Find

« Next Oldest | Next Newest »

Messages In This Thread

Zenith R600 TO garbled reception - by RodB - 01-30-2019, 10:02 PM

RE: Zenith R600 TO garbled reception - by OZ4 - 01-30-2019, 10:26 PM

RE: Zenith R600 TO garbled reception - by OZ4 - 01-30-2019, 11:15 PM

RE: Zenith R600 TO garbled reception - by David - 01-31-2019, 10:42 AM

RE: Zenith R600 TO garbled reception - by Phlogiston - 01-31-2019, 11:02 AM

RE: Zenith R600 TO garbled reception - by RodB - 04-12-2019, 02:02 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me