1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Late model 116B cabinet
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#33

02-01-2019, 06:42 PM
Actually it's medium walnut lacquer toner. I like the last pic the best 2nd is too red. A lot of it has to due with the lighting.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Late model 116B cabinet - by Radioroslyn - 12-04-2018, 01:16 PM
RE: Late model 116B cabinet - by OldRestorer - 12-04-2018, 02:26 PM
RE: Late model 116B cabinet - by Ron Ramirez - 12-04-2018, 02:51 PM
RE: Late model 116B cabinet - by Radioroslyn - 12-07-2018, 10:17 PM
RE: Late model 116B cabinet - by klondike98 - 12-07-2018, 10:53 PM
RE: Late model 116B cabinet - by Arran - 12-14-2018, 12:42 AM
RE: Late model 116B cabinet - by Radioroslyn - 12-17-2018, 04:25 PM
RE: Late model 116B cabinet - by Ron Ramirez - 12-17-2018, 04:32 PM
RE: Late model 116B cabinet - by Radioroslyn - 12-17-2018, 07:37 PM
RE: Late model 116B cabinet - by Ron Ramirez - 12-17-2018, 07:50 PM
RE: Late model 116B cabinet - by Arran - 12-19-2018, 05:29 AM
RE: Late model 116B cabinet - by Radioroslyn - 12-19-2018, 11:42 AM
RE: Late model 116B cabinet - by Ron Ramirez - 12-19-2018, 11:44 AM
RE: Late model 116B cabinet - by Arran - 12-20-2018, 06:30 AM
RE: Late model 116B cabinet - by OldRestorer - 12-20-2018, 07:54 AM
RE: Late model 116B cabinet - by Radioroslyn - 12-20-2018, 12:22 PM
RE: Late model 116B cabinet - by jcassity - 12-21-2018, 11:36 AM
RE: Late model 116B cabinet - by OldRestorer - 12-21-2018, 12:08 PM
RE: Late model 116B cabinet - by Ron Ramirez - 12-21-2018, 12:48 PM
RE: Late model 116B cabinet - by Radioroslyn - 12-21-2018, 05:17 PM
RE: Late model 116B cabinet - by OldRestorer - 12-23-2018, 08:06 AM
RE: Late model 116B cabinet - by Radioroslyn - 01-23-2019, 08:57 PM
RE: Late model 116B cabinet - by KCMike - 01-23-2019, 09:58 PM
RE: Late model 116B cabinet - by madsowry - 01-23-2019, 11:39 PM
RE: Late model 116B cabinet - by klondike98 - 01-24-2019, 08:35 AM
RE: Late model 116B cabinet - by Ron Ramirez - 01-24-2019, 08:54 AM
RE: Late model 116B cabinet - by Radioroslyn - 01-24-2019, 11:31 AM
RE: Late model 116B cabinet - by Ron Ramirez - 01-24-2019, 11:49 AM
RE: Late model 116B cabinet - by Phlogiston - 01-24-2019, 12:12 PM
RE: Late model 116B cabinet - by Radioroslyn - 01-24-2019, 02:20 PM
RE: Late model 116B cabinet - by jcassity - 02-01-2019, 06:37 PM
RE: Late model 116B cabinet - by Radioroslyn - 02-01-2019, 06:42 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5152 online users. [Complete List]
» 1 Member(s) | 5151 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration