1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Need a picture of a 37-640
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#8

10-29-2010, 09:02 AM
Ah ha - 37-3640A is a Canadian Philco.

I have very, very little info on Canadian-built Philco sets; I do know that the Canadian versions were often different from U.S. Philco models.

This must be one of them.

Does the cabinet have "spacer" boards on either side of the chassis? I suspect that cabinet is the same size as the USA Models 37-643B, 37-650B, 37-2650B, 37-660B and 37-665B, as it is identical in appearance. But the 37-640/3640 chassis is physically smaller than the chassis that would be used in that cabinet if it were a USA model.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
Need a picture of a 37-640 - by Snowmann35 - 10-27-2010, 09:21 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-27-2010, 09:22 PM
Re: Need a picture of a 37-640 - by Ron Ramirez - 10-27-2010, 09:30 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:03 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:04 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:09 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:17 PM
Re: Need a picture of a 37-640 - by Ron Ramirez - 10-29-2010, 09:02 AM
Re: Need a picture of a 37-640 - by Ron Ramirez - 10-29-2010, 09:07 AM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-29-2010, 05:03 PM
Re: Need a picture of a 37-640 - by codefox1 - 10-30-2010, 11:24 AM
Re: Need a picture of a 37-640 - by Steve Davis - 10-30-2010, 06:31 PM
Re: Need a picture of a 37-640 - by 7estatdef - 10-30-2010, 06:39 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-30-2010, 07:11 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-30-2010, 07:12 PM
Re: Need a picture of a 37-640 - by Steve Davis - 10-30-2010, 11:07 PM
Re: Need a picture of a 37-640 - by 7estatdef - 10-31-2010, 06:18 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration