1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Need a picture of a 37-640
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#13

10-30-2010, 06:39 PM
Hi Steve
Very interesting! Can you just glue the edge of the foam to the metal frame with rubber cement after gluing and centering the voice coil?
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Need a picture of a 37-640 - by Snowmann35 - 10-27-2010, 09:21 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-27-2010, 09:22 PM
Re: Need a picture of a 37-640 - by Ron Ramirez - 10-27-2010, 09:30 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:03 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:04 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:09 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-28-2010, 11:17 PM
Re: Need a picture of a 37-640 - by Ron Ramirez - 10-29-2010, 09:02 AM
Re: Need a picture of a 37-640 - by Ron Ramirez - 10-29-2010, 09:07 AM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-29-2010, 05:03 PM
Re: Need a picture of a 37-640 - by codefox1 - 10-30-2010, 11:24 AM
Re: Need a picture of a 37-640 - by Steve Davis - 10-30-2010, 06:31 PM
Re: Need a picture of a 37-640 - by 7estatdef - 10-30-2010, 06:39 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-30-2010, 07:11 PM
Re: Need a picture of a 37-640 - by Snowmann35 - 10-30-2010, 07:12 PM
Re: Need a picture of a 37-640 - by Steve Davis - 10-30-2010, 11:07 PM
Re: Need a picture of a 37-640 - by 7estatdef - 10-31-2010, 06:18 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 4051 online users. [Complete List]
» 3 Member(s) | 4048 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration