1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Latest on the 37-650
Bill Hutchinson
Member
***
Posts: 236
Threads: 30
Joined: Sep 2005
City: Minneapolis/St. Paul MN
#4

02-13-2006, 09:16 PM
Check out this procedure from Chuck's website on shadow meter servicing.

http://www.philcorepairbench.com/tips/svctip01.htm

It may not work too good if the set is out of alignment - I think I'd do that first. Icon_wink

Good luck!

Bill
Sent from my Pentium II on the AT&T Dial Network
Find
« Next Oldest | Next Newest »


Messages In This Thread
Latest on the 37-650 - by Robbie Roberts - 02-13-2006, 06:42 PM
[No subject] - by Bill Hutchinson - 02-13-2006, 09:02 PM
[No subject] - by Robbie Roberts - 02-13-2006, 09:07 PM
[No subject] - by Bill Hutchinson - 02-13-2006, 09:16 PM
[No subject] - by Chuck Schwark - 02-13-2006, 09:52 PM
[No subject] - by Robbie Roberts - 02-14-2006, 12:15 AM
[No subject] - by Robbie Roberts - 02-14-2006, 04:49 AM
[No subject] - by Steve Chambers - 02-14-2006, 08:14 AM
[No subject] - by Robbie Roberts - 02-14-2006, 01:32 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration