Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Farm Radio 38 123
#13

I checked the wires to the grid caps for continuity , they test fine.   I have an Eico 666 tube tester .  It doesn't list the 1A6 on the built in chart.   There's a socket it fits into, and a grid cap wire.
Is it possible to test the tube on this tester.   I can guess the filament voltage should be set at 2 volts.  I'm stumped on the rest.


Messages In This Thread
Philco Farm Radio 38 123 - by RCFlyer - 02-21-2019, 01:42 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-21-2019, 11:26 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-21-2019, 06:27 PM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-21-2019, 07:47 PM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-22-2019, 11:29 PM
RE: Philco Farm Radio 38 123 - by 35Z5 - 02-23-2019, 12:37 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-23-2019, 12:53 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-23-2019, 01:56 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-23-2019, 02:24 AM
RE: Philco Farm Radio 38 123 - by Stall-U-Rated - 02-23-2019, 02:44 AM
RE: Philco Farm Radio 38 123 - by Arran - 02-23-2019, 05:48 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-24-2019, 12:31 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-24-2019, 01:18 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-25-2019, 12:40 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-26-2019, 12:00 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 01:47 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 02:01 AM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-28-2019, 11:13 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 03:30 PM
RE: Philco Farm Radio 38 123 - by Radioroslyn - 02-28-2019, 09:40 PM
RE: Philco Farm Radio 38 123 - by RCFlyer - 02-28-2019, 10:04 PM
RE: Philco Farm Radio 38 123 - by Stall-U-Rated - 03-01-2019, 12:23 AM
RE: Philco Farm Radio 38 123 - by RCFlyer - 03-01-2019, 03:02 PM



Users browsing this thread: 9 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 5753 online users. [Complete List]
» 1 Member(s) | 5752 Guest(s)
Avatar

>