GE g-97

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

GE g-97

rperry
Junior Member

Posts: 37
Threads: 5
Joined: Jan 2019
City: Ranger State, Province, Country: Ga

#26

03-06-2019, 01:54 PM

After a 2 week break away from the radio with family matters, im back on it, I found the break and I took a couple wraps off the IF transformer that was reading open. Im now reading 7.4 ohms through the transformer instead of 6.4 ohms, hopefully this wont effect it much?

I am now getting a clear signal on pin 4 of the 42 tube but not one on the middle pin of the volume pot.

Ryan

Find

« Next Oldest | Next Newest »

Messages In This Thread

GE g-97 - by rperry - 02-09-2019, 01:18 PM

RE: GE g-97 - by mark123 - 02-11-2019, 03:11 PM

RE: GE g-97 - by rperry - 02-11-2019, 09:15 PM

RE: GE g-97 - by jcassity - 02-12-2019, 09:58 AM

RE: GE g-97 - by 35Z5 - 02-12-2019, 10:40 AM

RE: GE g-97 - by rperry - 02-12-2019, 12:04 PM

RE: GE g-97 - by rperry - 02-13-2019, 06:21 PM

RE: GE g-97 - by 35Z5 - 02-13-2019, 09:22 PM

RE: GE g-97 - by rperry - 02-14-2019, 10:37 AM

RE: GE g-97 - by 35Z5 - 02-14-2019, 12:41 PM

RE: GE g-97 - by rperry - 02-14-2019, 07:16 PM

RE: GE g-97 - by 35Z5 - 02-14-2019, 08:57 PM

RE: GE g-97 - by rperry - 02-14-2019, 09:04 PM

RE: GE g-97 - by 35Z5 - 02-15-2019, 11:02 AM

RE: GE g-97 - by rperry - 02-15-2019, 06:35 PM

RE: GE g-97 - by jcassity - 02-15-2019, 07:59 PM

RE: GE g-97 - by 35Z5 - 02-15-2019, 08:09 PM

RE: GE g-97 - by jcassity - 02-16-2019, 11:51 AM

RE: GE g-97 - by David - 02-16-2019, 12:15 PM

RE: GE g-97 - by rperry - 02-17-2019, 08:41 PM

RE: GE g-97 - by rperry - 02-19-2019, 02:07 PM

RE: GE g-97 - by Kenneth F. Besso Jr. - 02-19-2019, 07:46 PM

RE: GE g-97 - by rperry - 02-19-2019, 10:18 PM

RE: GE g-97 - by 35Z5 - 02-20-2019, 03:07 PM

RE: GE g-97 - by morzh - 02-20-2019, 03:43 PM

RE: GE g-97 - by rperry - 03-06-2019, 01:54 PM

RE: GE g-97 - by rperry - 03-08-2019, 07:31 PM

RE: GE g-97 - by Radioroslyn - 03-08-2019, 08:21 PM

RE: GE g-97 - by rperry - 03-15-2019, 12:39 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 3891 online users. [Complete List]
» 1 Member(s) | 3890 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me