Latest on the 37-650

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Latest on the 37-650

Robbie Roberts
Member

Posts: 147
Threads: 28
Joined: Nov 2005

02-14-2006, 01:32 PM

Thanks Steve- I've been through the band switches three or four times, and I'm pretty certain they're in right... Too blasted many of them, if you ask me!
But I went through them, manually cleaned them, and reassembled completely. It took a while, the pictures look upside down, but once I reversed the schematic, and understod the shaded/solid areas, I got them figured out. So I'm pretty confident with the RF section... And the tone of the RF generator is coming through as it should. Also, there is that one SW station coming through, I think if the switches were in wrong, it wouldn't even give me that.

Scott

Old Cars, Old Radios, Old Pipes and Young Women... What more is there?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Latest on the 37-650 - by Robbie Roberts - 02-13-2006, 06:42 PM

[No subject] - by Bill Hutchinson - 02-13-2006, 09:02 PM

[No subject] - by Robbie Roberts - 02-13-2006, 09:07 PM

[No subject] - by Bill Hutchinson - 02-13-2006, 09:16 PM

[No subject] - by Chuck Schwark - 02-13-2006, 09:52 PM

[No subject] - by Robbie Roberts - 02-14-2006, 12:15 AM

[No subject] - by Robbie Roberts - 02-14-2006, 04:49 AM

[No subject] - by Steve Chambers - 02-14-2006, 08:14 AM

[No subject] - by Robbie Roberts - 02-14-2006, 01:32 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 4904 online users. [Complete List]
» 3 Member(s) | 4901 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me