[morzh]

As in the previous one, some tubular caps are made of a thin paper shell filled with tar. In the former I was able to extract the cartridge and restuff them, but in this one both of the caps (same type) refused to let the tar out.
So I scanned what was left, photoshopped it and created my own caps.
I needed a paper sleeve, and having none available created my own from a backing of a notepad.
One mistake I made was making the walls to thick but it wasn't too bad.

Here it is:

   
The sleeve. Made by spraying glue and rolling around an exacto knife handle.

   
The labels. I made several sizes as well as photoshopped more or less.

   
Then in the same way spray the glue and roll on the labels.

And finally, put the cap insde and pot with hotglue.
As I sad, the walls were too thick so the glue had to pour over. It's ok but next time I will know to only use 2 layers.