Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Can you identify?
#8

Yep, thats what it is... two chrome chassis, two giant speakers... With parallel push-pull 2A3's that thing will thump, but will cost an arm and a leg to replace those tubes if needed...

https://www.radiomuseum.org/r/montgomery_62_197.html


Messages In This Thread
Can you identify? - by rfeenstra - 04-11-2019, 10:03 AM
RE: Can you identify? - by Jake Blake - 04-11-2019, 10:06 AM
RE: Can you identify? - by KCMike - 04-11-2019, 11:10 AM
RE: Can you identify? - by morzh - 04-11-2019, 11:24 AM
RE: Can you identify? - by rfeenstra - 04-11-2019, 11:28 AM
RE: Can you identify? - by morzh - 04-11-2019, 11:38 AM
RE: Can you identify? - by KCMike - 04-11-2019, 12:52 PM
RE: Can you identify? - by sdradioman - 04-11-2019, 01:45 PM
RE: Can you identify? - by rfeenstra - 04-11-2019, 02:59 PM
RE: Can you identify? - by sdradioman - 04-11-2019, 04:00 PM
RE: Can you identify? - by gregb - 04-11-2019, 07:55 PM
RE: Can you identify? - by rfeenstra - 04-11-2019, 08:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>