Schematic GE-50-C

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Schematic GE-50-C

ducretet
Member

Posts: 81
Threads: 24
Joined: Aug 2018
City: LAVERN-SUBIRATS State, Province, Country: ESPAÑA

04-20-2019, 02:14 PM

Good Morning,
I am looking for the scheme of the General Electric 50-C radio model.
Thanks in advance.
Regards,
Ferran

(This post was last modified: 04-20-2019, 02:17 PM by ducretet.)

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Schematic GE-50-C - by ducretet - 04-20-2019, 02:14 PM

RE: Schematic GE-50-C - by Radioroslyn - 04-20-2019, 02:20 PM

RE: Schematic GE-50-C - by 462ron - 04-21-2019, 09:24 AM

RE: Schematic GE-50-C - by ducretet - 04-21-2019, 02:44 PM

RE: Schematic GE-50-C - by ducretet - 04-21-2019, 03:09 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me