1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 41-265 Code 121
copiertech
Junior Member
**
Posts: 8
Threads: 3
Joined: Dec 2011
City: Fredericton State, Province, Country: New Brunswick
#1

05-22-2019, 11:41 AM
Hi:  I  am wondering if there is  a difference between the  41-265  and  the 41-265 code 121.  I ask because I am  using a 41-265 schematic and  see a difference in a couple of caps shown in the photo of the schematic.    The schematic says #49 is a .006uf cap. Instead it is a .01uf/1200 volt cap.   #47 is supposed to be a .01 uf cap but is .05uf .   The label on my chassis says  model 41  code 121  (shown in photo) . It is possible someone changed the caps at some point.   It looks like the electrolytics had been changed decades ago.  I'd be interested if anyone who has restored this chassis could enlighten me on what they found.


Attached Files Image(s)
           
(This post was last modified: 05-22-2019, 11:49 AM by copiertech.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 41-265 Code 121 - by copiertech - 05-22-2019, 11:41 AM
RE: Philco 41-265 Code 121 - by klondike98 - 05-22-2019, 01:28 PM
RE: Philco 41-265 Code 121 - by copiertech - 05-22-2019, 01:47 PM
RE: Philco 41-265 Code 121 - by klondike98 - 05-22-2019, 01:58 PM
RE: Philco 41-265 Code 121 - by Radioroslyn - 05-22-2019, 04:47 PM
RE: Philco 41-265 Code 121 - by Ron Ramirez - 05-22-2019, 05:46 PM
RE: Philco 41-265 Code 121 - by klondike98 - 05-22-2019, 05:48 PM
RE: Philco 41-265 Code 121 - by copiertech - 05-25-2019, 09:56 PM
RE: Philco 41-265 Code 121 - by klondike98 - 05-26-2019, 08:54 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4882 online users. [Complete List]
» 1 Member(s) | 4881 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration