Model 89 code 123 #36 tube

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 89 code 123 #36 tube

tmr63
Junior Member

Posts: 21
Threads: 7
Joined: Apr 2017
City: Ocala State, Province, Country: FL

05-30-2019, 01:26 PM

I am Restoring a model 89 with the usual coil problems. I found good information on rewinding the # 14 oscillator coil.

I also have a bad secondary winding in the 1st if coil #18. Did anyone save their notes on this coil?

I assume the wind is clockwise however does anyone have the number of turns and the wire size.
Is the wire size critical or is close enough ok?

Thanks for any help you can give me>

Tom

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 89 code 123 #36 tube - by tmr63 - 05-30-2019, 01:26 PM

RE: Model 89 code 123 #36 tube - by Jake Blake - 05-30-2019, 04:44 PM

RE: Model 89 code 123 #36 tube - by Ron Ramirez - 05-30-2019, 05:34 PM

RE: Model 89 code 123 #36 tube - by tmr63 - 05-31-2019, 05:48 PM

RE: Model 89 code 123 #36 tube - by Steve Davis - 05-31-2019, 07:15 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me