Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

help finding the antenna on my 37-660 ?
#7

Hello, Tim: I'm at my daughter's house right now and do not have Ron's book handy to refer to, but I believe your 37-660 has regular broadcast (AM) and 3 bands of shortwave. You will discover that as a rule the lower frequency bands are better at night and the higher frequency bands are better at day. However, no doubt with a decent antenna you will recieve low freq stationd during the day and vice versa.

A "longwire" antenna connected to your antenna post on the radio should be sufficient. As a rule, longer is better, but it really depends on how much room you have available for this. I would not recomment hanging an antenna outside unless you know how to protect it from potential lightning strikes.

I personally have one "longwire" antenna under the eave of my front porch in order to protect it from lightning, and inside my home I have several "loop" antennas that are either hung tight to the ceiling or are on a wall. You can make a "loop" simply bystringing your antenna's in a square or rectangular fashion. I use eye screws to run the wire through.

I have many rolls of "claymore" wire that I scavenged during my 25 years in the USMC that I use for antenna wire. This is a habit I developed when needing to construct expedient antennas for long range short wave radio reports using a small, man packed 20 watt HF radio. The wire came from expended claymore mine kits.

But since claymore mines are not routinely used in civilian life, I recommend going to Lowes or Home Depot and purchasing 20 to 30 feet of "stereo" wire. The copper is better for the antenna, the aluminum is better for grounds, doublets, or counterpoises.


Messages In This Thread
help finding the antenna on my 37-660 ? - by Tim - 11-27-2010, 02:54 PM
Re: help finding the antenna on my 37-660 ? - by TA Forbes - 12-03-2010, 10:56 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently 5664 online users. [Complete List]
» 1 Member(s) | 5663 Guest(s)
Avatar

>