Need help on 40-180 chassis

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Need help on 40-180 chassis

Radioroslyn
Phorum Expert

Posts: 7,287
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#21

06-08-2019, 10:47 AM

Hi Bill and welcome to the fray,
If you need an output transformer here is a reasonably priced one. https://www.tubesandmore.com/products/tr...output-8-w

GL w/your project.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

(This post was last modified: 06-08-2019, 10:49 AM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Need help on 40-180 chassis - by BillT52 - 06-06-2019, 08:45 AM

RE: Need help on 40-180 chassis - by morzh - 06-06-2019, 11:11 AM

RE: Need help on 40-180 chassis - by klondike98 - 06-06-2019, 12:18 PM

RE: Need help on 40-180 chassis - by LarryFS - 06-06-2019, 01:12 PM

RE: Need help on 40-180 chassis - by morzh - 06-06-2019, 02:21 PM

RE: Need help on 40-180 chassis - by BillT52 - 06-06-2019, 02:54 PM

RE: Need help on 40-180 chassis - by LarryFS - 06-06-2019, 06:03 PM

RE: Need help on 40-180 chassis - by morzh - 06-06-2019, 08:40 PM

RE: Need help on 40-180 chassis - by madsowry - 06-06-2019, 09:26 PM

RE: Need help on 40-180 chassis - by morzh - 06-06-2019, 09:56 PM

RE: Need help on 40-180 chassis - by BillT52 - 06-07-2019, 09:06 AM

RE: Need help on 40-180 chassis - by morzh - 06-07-2019, 09:54 AM

RE: Need help on 40-180 chassis - by BillT52 - 06-07-2019, 10:30 AM

RE: Need help on 40-180 chassis - by morzh - 06-07-2019, 10:39 AM

RE: Need help on 40-180 chassis - by BillT52 - 06-07-2019, 04:04 PM

RE: Need help on 40-180 chassis - by BillT52 - 06-07-2019, 05:42 PM

RE: Need help on 40-180 chassis - by morzh - 06-07-2019, 09:23 PM

RE: Need help on 40-180 chassis - by BillT52 - 06-07-2019, 10:29 PM

RE: Need help on 40-180 chassis - by morzh - 06-07-2019, 11:00 PM

RE: Need help on 40-180 chassis - by BillT52 - 06-08-2019, 06:54 AM

RE: Need help on 40-180 chassis - by Radioroslyn - 06-08-2019, 10:47 AM

RE: Need help on 40-180 chassis - by morzh - 06-08-2019, 11:06 AM

RE: Need help on 40-180 chassis - by BillT52 - 06-08-2019, 12:37 PM

RE: Need help on 40-180 chassis - by Radioroslyn - 06-08-2019, 01:24 PM

RE: Need help on 40-180 chassis - by morzh - 06-08-2019, 02:44 PM

RE: Need help on 40-180 chassis - by Radioroslyn - 06-08-2019, 07:06 PM

RE: Need help on 40-180 chassis - by BillT52 - 06-25-2019, 11:36 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me