schematic needed, model 60 chasses type 366A

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

schematic needed, model 60 chasses type 366A

Dan Walker
Senior Member

Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA

07-12-2019, 11:06 PM

Thanks for the replies.
As I understand it resistor#44 and cap #43 were not in the later models.
     I took out an electrolytic cap to restuff it and I see the other one has two places to connect to AND a ground connection.   [ see the red dot and the silver one , in the photo]
   Hopefully I can figure it out with the right paperwork.
    Someone has been in there messing around. that is a good reason the get the right schematic.
Philco radios have so many different schematics and models for the same radio.
     Thank you all for the input as you guys are the Philco experts.
Dan in calgary

Attached Files Image(s)

Living in Calgary Alberta

Find

« Next Oldest | Next Newest »

Messages In This Thread

schematic needed, model 60 chasses type 366A - by Dan Walker - 07-12-2019, 03:00 PM

RE: schematic needed, model 60 chasses type 366A - by David - 07-12-2019, 04:41 PM

RE: schematic needed, model 60 chasses type 366A - by Radioroslyn - 07-12-2019, 05:12 PM

RE: schematic needed, model 60 chasses type 366A - by David - 07-12-2019, 07:49 PM

RE: schematic needed, model 60 chasses type 366A - by Dan Walker - 07-12-2019, 11:06 PM

RE: schematic needed, model 60 chasses type 366A - by Radioroslyn - 07-13-2019, 08:39 AM

RE: schematic needed, model 60 chasses type 366A - by Radioroslyn - 07-13-2019, 09:29 AM

RE: schematic needed, model 60 chasses type 366A - by Dan Walker - 07-13-2019, 03:43 PM

RE: schematic needed, model 60 chasses type 366A - by Radioroslyn - 07-13-2019, 04:14 PM

RE: schematic needed, model 60 chasses type 366A - by Dan Walker - 07-13-2019, 04:31 PM

RE: schematic needed, model 60 chasses type 366A - by Radioroslyn - 07-13-2019, 05:31 PM

RE: schematic needed, model 60 chasses type 366A - by Dan Walker - 07-13-2019, 05:43 PM

RE: schematic needed, model 60 chasses type 366A - by klondike98 - 07-13-2019, 06:00 PM

RE: schematic needed, model 60 chasses type 366A - by Dan Walker - 07-13-2019, 07:19 PM

RE: schematic needed, model 60 chasses type 366A - by Radioroslyn - 07-13-2019, 07:25 PM

RE: schematic needed, model 60 chasses type 366A - by Dan Walker - 07-15-2019, 09:34 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me