Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-650 Current Symptoms
#1

Here's the latest on the 37-650 situation... Apparently I did something right: I have been receiving on one of the SW bands- 5.8 to 11.5. Mainly religious stuff, and slightly off - I was receiving one station on 7.75 which said it's broadcast was at 7.65, so .1 difference. Not major, probably just a dial issue.

I am also getting signals of low strength on the other SW band(12-16) but AM/Broadcast is still nothing but junk. I will try more adjustments tonight on the set. I am trying an antenna- the base antenna from my 39-116! I just rewound it with its original wire, just to have something organized to work with...

Comments? Suggestions?
Thanks!
Scott

Old Cars, Old Radios, Old Pipes and Young Women... What more is there?


Messages In This Thread
37-650 Current Symptoms - by Robbie Roberts - 02-19-2006, 07:59 PM
[No subject] - by Robbie Roberts - 02-20-2006, 12:59 AM
[No subject] - by Robbie Roberts - 02-20-2006, 03:01 AM
[No subject] - by Chuck Schwark - 02-20-2006, 10:05 AM
[No subject] - by Robbie Roberts - 02-20-2006, 10:43 AM
[No subject] - by Chuck Schwark - 02-20-2006, 10:55 AM
[No subject] - by Robbie Roberts - 02-20-2006, 11:15 AM
[No subject] - by Ron Ramirez - 02-20-2006, 11:33 AM
[No subject] - by Robbie Roberts - 02-20-2006, 11:36 AM
[No subject] - by Ron Ramirez - 02-20-2006, 03:37 PM
[No subject] - by Robbie Roberts - 02-21-2006, 01:01 AM
More info - by Robbie Roberts - 02-21-2006, 11:05 AM
Further Results - by Robbie Roberts - 02-21-2006, 11:54 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 4101 online users. [Complete List]
» 1 Member(s) | 4100 Guest(s)
Avatar

>