Westinghouse H-303P4,

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Westinghouse H-303P4,

Eric
Senior Member

Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA

07-15-2019, 03:31 PM

Hi,
I have a Westinghouse H303P4 portable the prints here.

http://www.nostalgiaair.org/pagesbymodel...024160.pdf

I have recapped it and replaced the resistors that were out of tolerance. I had one bad tube the 1U5.
The If's were peaked (slugs) to 455kc no problem then I went next in the instructions to do the OSC (C8) at 1615kc feeding the signal into the tuning cap C5 and I cannot pick up a tone at all! The OSC coils read 12 and 2.6 ohms so they look to be ok. What am I missing? Thanks

Eric

Find

« Next Oldest | Next Newest »

Messages In This Thread

Westinghouse H-303P4, - by Eric - 07-15-2019, 03:31 PM

RE: Westinghouse H-303P4, - by Radioroslyn - 07-15-2019, 04:03 PM

RE: Westinghouse H-303P4, - by Eric - 07-15-2019, 05:34 PM

RE: Westinghouse H-303P4, - by Radioroslyn - 07-15-2019, 05:47 PM

RE: Westinghouse H-303P4, - by Eric - 07-16-2019, 04:11 PM

RE: Westinghouse H-303P4, - by Radioroslyn - 07-17-2019, 07:26 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6797 online users. [Complete List]
» 1 Member(s) | 6796 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me