Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Looking for a communications receiver?
#30

WA3UAY - Sorry, not happening. Nothing against the ham radio hobby at all, I just don't see myself getting into it this late in the game. I have enough expensive hobbies already (radios, stereo equipment, computers). So I guess that Send-Rec switch will remain on Rec.

Russ - The fellow who sold the HQ-129-X to me included a photocopy of the owner's manual with schematic. Inside, it states that it was made for use with a 6 ohm speaker. So I figured 8 ohm headphones would be good enough for a test. It has a single ended 6V6 output so that should be good for around 2 to 5 watts, depending on circuitry.

And thirtiesradio, I failed to mention that I like your two Hammarlunds as well as that world time clock. Icon_thumbup

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
RE: Looking for a communications receiver? - by Ron Ramirez - 08-09-2019, 02:49 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 3265 online users. [Complete List]
» 3 Member(s) | 3262 Guest(s)
AvatarAvatarAvatar

>