Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Please ID Silvertone
#2

It's a King-Hinner set made for Silvertone. I have this one:
[Image: https://proxy.duckduckgo.com/iu/?u=http%...up.jpg&f=1]
Pic stolen from the net.
Don't know if there is a diagram for it but there is not must difference between most of the battery Neutrodyne TRF sets. This will get you in the ballpark: http://www.nostalgiaair.org/pagesbymodel...017930.pdf
The tricky part on this one is getting the chassis out. It comes out thru the front but you have to remove the wood trim to access the screws along the edge of the panel.

GLOM

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Please ID Silvertone - by vecher - 08-09-2019, 03:11 PM
RE: Please ID Silvertone - by Radioroslyn - 08-09-2019, 03:51 PM
RE: Please ID Silvertone - by vecher - 08-09-2019, 07:39 PM
RE: Please ID Silvertone - by Chas - 08-09-2019, 09:14 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2107 online users. [Complete List]
» 2 Member(s) | 2105 Guest(s)
AvatarAvatar

>