Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

AM transmitter use
#11

Here's a picture of the transmitter that Terry sells:

   

It has a digital frequency display and a speaker you can turn on to hear the source material that you're feeding into it.  That comes in handy just to verify your source actually has audio.  This version also plugs in directly to the outlet without the hassle (or noise) of a wall wart.

Terry Layman:

layvinrad <at> mymetronet <dot> net

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
AM transmitter use - by murf - 08-10-2019, 02:55 PM
RE: qm transmiter use - by LarryFS - 08-10-2019, 03:36 PM
RE: qm transmiter use - by Eliot Ness - 08-10-2019, 03:48 PM
RE: qm transmiter use - by murf - 08-10-2019, 09:32 PM
RE: qm transmiter use - by Eliot Ness - 08-11-2019, 08:03 AM
RE: qm transmiter use - by mikethedruid - 08-11-2019, 01:19 PM
RE: qm transmiter use - by Eliot Ness - 08-11-2019, 02:00 PM
RE: AM transmitter use - by mikethedruid - 08-11-2019, 06:18 PM
RE: AM transmitter use - by Eliot Ness - 08-11-2019, 08:07 PM
RE: AM transmitter use - by mikethedruid - 08-11-2019, 08:36 PM
RE: AM transmitter use - by Eliot Ness - 08-14-2019, 01:10 PM
RE: AM transmitter use - by rfeenstra - 08-14-2019, 03:25 PM
RE: AM transmitter use - by Eliot Ness - 08-14-2019, 09:19 PM
RE: AM transmitter use - by Phlogiston - 08-15-2019, 07:37 PM
RE: AM transmitter use - by tbone - 08-27-2019, 07:57 PM
RE: AM transmitter use - by TV MAN - 09-18-2019, 01:34 PM
RE: AM transmitter use - by Phlogiston - 09-19-2019, 12:17 PM
RE: AM transmitter use - by W8ZV - 09-27-2019, 09:57 PM
RE: AM transmitter use - by fenbach - 10-01-2019, 07:50 PM
RE: AM transmitter use - by TV MAN - 10-02-2019, 02:28 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>