37-650 Current Symptoms

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

37-650 Current Symptoms

Robbie Roberts
Member

Posts: 147
Threads: 28
Joined: Nov 2005

#11

02-21-2006, 01:01 AM

I'm looking over the wafer switches, but not seeing anything yet. I am probably going to pull the BC coils, and recheck them... With that thought in mind, I do recall replacing the leads on one section of the RF section BC coil- I think it was leads 3&4, on part 9, the BC RF Trans coil. They were the thin woven kind, sort of like the braid on shielded wire, but much lighter. I replaces it with a size about twice/3X's as thick- Could THIS be modifying the resistance to an unmanagable point?

Is it possible to swap in the one from the 38-3 chassis I have parted out?(I am going to print out the specs on that in a minute, but thought I'd ask...)

Scott

Old Cars, Old Radios, Old Pipes and Young Women... What more is there?

Find

« Next Oldest | Next Newest »

Messages In This Thread

37-650 Current Symptoms - by Robbie Roberts - 02-19-2006, 07:59 PM

[No subject] - by Robbie Roberts - 02-20-2006, 12:59 AM

[No subject] - by Robbie Roberts - 02-20-2006, 03:01 AM

[No subject] - by Chuck Schwark - 02-20-2006, 10:05 AM

[No subject] - by Robbie Roberts - 02-20-2006, 10:43 AM

[No subject] - by Chuck Schwark - 02-20-2006, 10:55 AM

[No subject] - by Robbie Roberts - 02-20-2006, 11:15 AM

[No subject] - by Ron Ramirez - 02-20-2006, 11:33 AM

[No subject] - by Robbie Roberts - 02-20-2006, 11:36 AM

[No subject] - by Ron Ramirez - 02-20-2006, 03:37 PM

[No subject] - by Robbie Roberts - 02-21-2006, 01:01 AM

More info - by Robbie Roberts - 02-21-2006, 11:05 AM

Further Results - by Robbie Roberts - 02-21-2006, 11:54 AM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 5289 online users. [Complete List]
» 1 Member(s) | 5288 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me