1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Suggestions for a good digital signal/function generator?
W8ZV
Junior Member
**
Posts: 23
Threads: 2
Joined: Dec 2018
City: Coopersville State, Province, Country: MI
#23

10-09-2019, 01:21 PM
I see you bought a B&K 4040.  Good for you.  If it doesn't have a manual with it, you can get one from B&K.  They support all their stuff for a LONG time.  They just discontinued that model too.  You can get that manual by going to their website and filling out the request form.  I've had them send me stuff free.  I like the American built/sold stuff better than the Chinese stuff.  The product support is LOTS better.
Kim Herron W8ZV
w8zv at goldenradioservice.com
1-616-677-3706
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Suggestions for a good digital signal/function generator? - by W8ZV - 10-09-2019, 01:21 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 6664 online users. [Complete List]
» 2 Member(s) | 6662 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment