1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
1935 655MX
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#4

12-31-2010, 10:38 PM
Agree with Ron it's a nice one. P/P triode connected 42 with a 42 driver. Same set up that they use in the higher end Philco's. Also has a RF amp stage which will give you good sensitive.
I'd jump on it!!
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
1935 655MX - by JGatewood - 12-31-2010, 08:39 PM
Re: 1935 655MX - by greg denney - 12-31-2010, 09:20 PM
Re: 1935 655MX - by Ron Ramirez - 12-31-2010, 09:31 PM
Re: 1935 655MX - by 7estatdef - 12-31-2010, 10:38 PM
Re: 1935 655MX - by Glenn Roberts - 01-01-2011, 10:33 AM
Re: 1935 655MX - by Ron Ramirez - 01-01-2011, 11:31 AM
Re: 1935 655MX - by bigron - 01-02-2011, 09:52 PM
Re: 1935 655MX - by Ron Ramirez - 01-02-2011, 09:56 PM
Re: 1935 655MX - by Glenn Roberts - 01-03-2011, 05:25 AM
Re: 1935 655MX - by bigron - 01-08-2011, 12:29 PM
Re: 1935 655MX - by greg denney - 01-20-2011, 02:20 AM
Re: 1935 655MX - by Ron Ramirez - 01-20-2011, 09:07 AM
Re: 1935 655MX - by greg denney - 01-20-2011, 02:01 PM
Re: 1935 655MX - by Ron Ramirez - 01-20-2011, 02:08 PM
Re: 1935 655MX - by greg denney - 01-20-2011, 02:14 PM
Re: 1935 655MX - by Glenn Roberts - 01-20-2011, 07:07 PM
Re: 1935 655MX - by Ron Ramirez - 01-20-2011, 07:26 PM
Re: 1935 655MX - by codefox1 - 01-20-2011, 10:49 PM
Re: 1935 655MX - by Glenn Roberts - 01-27-2011, 04:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios