1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-12 Chassis confusion
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#7

10-17-2019, 04:31 PM
Owing to the length of those transformer leads, the transformer was obviously replaced at some point and the repairman did not cut off excess wire leads (poor practice).

Perhaps the taped-off leads are for an unused 5V winding? Just a guess.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
38-12 Chassis confusion - by mrmurr2003 - 10-17-2019, 12:57 PM
RE: 38-12 Chassis confusion - by morzh - 10-17-2019, 01:21 PM
RE: 38-12 Chassis confusion - by klondike98 - 10-17-2019, 01:26 PM
RE: 38-12 Chassis confusion - by morzh - 10-17-2019, 01:47 PM
RE: 38-12 Chassis confusion - by mrmurr2003 - 10-17-2019, 02:02 PM
RE: 38-12 Chassis confusion - by klondike98 - 10-17-2019, 02:59 PM
RE: 38-12 Chassis confusion - by Ron Ramirez - 10-17-2019, 04:31 PM
RE: 38-12 Chassis confusion - by mrmurr2003 - 10-17-2019, 08:16 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Rusty Tuning Condenser
Hello Rob. I've also heard of soaking the tuning cap in automatic transmission fluid. This was an old trick we used to...GarySP — 06:14 PM
Rusty Tuning Condenser
Gary, I once had a tuning cap that had a thick coat of kitchen grease and grime. So I had heard about brake cleaner bei...RodB — 06:03 PM
Rusty Tuning Condenser
I've put tuning caps with mica removed and vanes wide open in the dishwasher and ran through a cycle. When the dishwash...GarySP — 05:42 PM
Rusty Tuning Condenser
I do not think Philco 91 used pot metal for the tuning cap. Also, in 1930-s pot metal did not have iron, being mostly co...morzh — 04:56 PM
38-10T chassis Restoration begins
Rich do you dunk the whole razor in there with it turned on to get a good mix? :lol:dconant — 04:48 PM
Rusty Tuning Condenser
David, RodB says to watch out for pot metal as it might dissolve in vinegar. I think there might be some in there. I thi...dconant — 04:40 PM
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM

[-]
Who's Online
There are currently 3676 online users. [Complete List]
» 2 Member(s) | 3674 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration