1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Latest on the 37-650
Chuck Schwark
Phorum Expert
*****
Posts: 1,703
Threads: 55
Joined: Sep 2005
City: Evanston, IL
#11

02-22-2006, 09:00 PM
If you used your signal generator to setup the IF, then you should also use it to align the AM band, per the Philco instructions.
Chuck Schwark,
The Philco Repair Bench
[Image: http://www.philcorepairbench.com/images/philog3tiny.gif]
http://www.philcorepairbench.com
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Latest on the 37-650 - by Robbie Roberts - 02-21-2006, 10:57 PM
[No subject] - by Bill Hutchinson - 02-22-2006, 06:39 PM
[No subject] - by Robbie Roberts - 02-22-2006, 06:41 PM
[No subject] - by Bill Hutchinson - 02-22-2006, 06:50 PM
[No subject] - by Chuck Schwark - 02-22-2006, 07:35 PM
[No subject] - by Robbie Roberts - 02-22-2006, 07:38 PM
[No subject] - by Chuck Schwark - 02-22-2006, 08:29 PM
[No subject] - by Robbie Roberts - 02-22-2006, 08:35 PM
[No subject] - by Steve Chambers - 02-22-2006, 08:44 PM
[No subject] - by Robbie Roberts - 02-22-2006, 08:47 PM
[No subject] - by Chuck Schwark - 02-22-2006, 09:00 PM
[No subject] - by Robbie Roberts - 02-23-2006, 12:56 AM
[No subject] - by Derek D - 02-23-2006, 01:33 AM
[No subject] - by Robbie Roberts - 02-23-2006, 01:40 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration