philco71/91

Thread Rating:

philco71/91

mg34.42
Member

Posts: 88
Threads: 35
Joined: Dec 2013
City: Tulsa, OK

10-29-2019, 10:49 PM

the lines are the ghost of radio past haunting the radio. actually its the lighting I got a new camera

Find

« Next Oldest | Next Newest »

Messages In This Thread

philco71/91 - by mg34.42 - 10-27-2019, 10:31 PM

RE: philco71/91 - by morzh - 10-27-2019, 11:55 PM

RE: philco71/91 - by mg34.42 - 10-29-2019, 10:49 PM

RE: philco71/91 - by mikethedruid - 10-30-2019, 12:01 AM

RE: philco71/91 - by Steve Davis - 10-30-2019, 02:04 PM

RE: philco71/91 - by Phlogiston - 10-30-2019, 02:14 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4951 online users. [Complete List]
» 2 Member(s) | 4949 Guest(s)