1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Loose wire...
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#12

01-06-2011, 07:34 PM
Open winding on the antenna coil.
Measure the resistance from ground the the antenna post with the set unplugged and volume all the way up. Should show a low resistance like a few ohms. If it higher than that the small winding on the ant coil is open. Remove coil and rewind(easy). About 25t of 36G will work fine
Good luck
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Loose wire... - by Kico - 01-03-2011, 09:50 AM
Re: Loose wire... - by 7estatdef - 01-03-2011, 10:08 AM
Re: Loose wire... - by Kico - 01-03-2011, 10:24 AM
Re: Loose wire... - by 7estatdef - 01-03-2011, 12:14 PM
Re: Loose wire... - by Kico - 01-03-2011, 12:33 PM
Re: Loose wire... - by 7estatdef - 01-03-2011, 03:01 PM
Re: Loose wire... - by Kico - 01-05-2011, 05:47 PM
Re: Loose wire... - by 7estatdef - 01-05-2011, 06:16 PM
Re: Loose wire... - by gary rabbitt - 01-05-2011, 11:18 PM
Re: Loose wire... - by gary rabbitt - 01-06-2011, 01:02 AM
Re: Loose wire... - by Kico - 01-06-2011, 03:19 PM
Re: Loose wire... - by 7estatdef - 01-06-2011, 07:34 PM
Re: Loose wire... - by Kico - 01-06-2011, 08:51 PM
Re: Loose wire... - by 7estatdef - 01-06-2011, 09:33 PM
Re: Loose wire... - by Kico - 01-06-2011, 09:47 PM
Re: Loose wire... - by 7estatdef - 01-06-2011, 10:32 PM
Re: Loose wire... - by Kico - 01-07-2011, 04:01 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration