1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Loose wire...
Radioroslyn
Phorum Expert
*****
Posts: 7,269
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#14

01-06-2011, 08:33 PM
Yup Coil is open.
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Loose wire... - by Kico - 01-03-2011, 08:50 AM
Re: Loose wire... - by 7estatdef - 01-03-2011, 09:08 AM
Re: Loose wire... - by Kico - 01-03-2011, 09:24 AM
Re: Loose wire... - by 7estatdef - 01-03-2011, 11:14 AM
Re: Loose wire... - by Kico - 01-03-2011, 11:33 AM
Re: Loose wire... - by 7estatdef - 01-03-2011, 02:01 PM
Re: Loose wire... - by Kico - 01-05-2011, 04:47 PM
Re: Loose wire... - by 7estatdef - 01-05-2011, 05:16 PM
Re: Loose wire... - by gary rabbitt - 01-05-2011, 10:18 PM
Re: Loose wire... - by gary rabbitt - 01-06-2011, 12:02 AM
Re: Loose wire... - by Kico - 01-06-2011, 02:19 PM
Re: Loose wire... - by 7estatdef - 01-06-2011, 06:34 PM
Re: Loose wire... - by Kico - 01-06-2011, 07:51 PM
Re: Loose wire... - by 7estatdef - 01-06-2011, 08:33 PM
Re: Loose wire... - by Kico - 01-06-2011, 08:47 PM
Re: Loose wire... - by 7estatdef - 01-06-2011, 09:32 PM
Re: Loose wire... - by Kico - 01-07-2011, 03:01 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Help with Readrite 410 tube tester
I fixed it. The filament selector switch is not that great of quality. Cleaned it and it takes some fiddling with to get...daveone23 — 06:58 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
It's a vacuum tube set and it's over 60 years old.  My uncle acquired it for my parents when Philco was done with it, an...jeibner — 10:24 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
Hi J Eibner, Welcome to the Phorum.  Lots of Phriendly Pholks with Phine (See a pattern here?) advice. It is very...MrFixr55 — 09:54 PM
Philco 89B code 123 newbie
Or you can do what Terry suggests. Thx Terry for remembering that. A lot cheaper. I remember an article about that, b...MrFixr55 — 09:07 PM
Philco 48-200 alignment questions
Thanks to everybody for all the info so far. RodB, thanks for the additional info. I worked on this radio years ago a...transitony — 08:40 PM
Philco 89B code 123 newbie
Now that I've been thinking about it somewhere I saw a replacement made using a section of pvc pipe and a cap to cover t...Radioroslyn — 08:25 PM
Philco 48-200 alignment questions
Terry's gimmick cap is two insulated wires twisted together about 2 inches long, one wire attaches to the generator outp...RodB — 07:46 PM
Philco 48-200 alignment questions
Hi, in this case I would be certain that pin 7, which is B-, of the 14A7 is not "hot". If it is then reverse t...RodB — 07:39 PM
Philco 48-200 alignment questions
Yup. The gimmick is to take the place of the 100mmfd cap you don't have.Radioroslyn — 07:34 PM
Philco 48-200 alignment questions
Thanks for the reply Terry. Yes I am definitely using an isolation transformer. If I work with your method and connec...transitony — 07:29 PM

[-]
Who's Online
There are currently 3023 online users. [Complete List]
» 2 Member(s) | 3021 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration