1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Parts list or Volume Pot Value
Radioroslyn
Phorum Expert
*****
Posts: 7,288
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#10

01-10-2011, 04:48 AM
ps Your pot isn't wired properly as per the diagram. The terminal to the right should be connected to the chassis. the next one should have a .01 going back to pin 3 of the 7C6. The terminal to the left should be connected to .01 cap that goes to the junction of two 470k resistors and a 100uufd cap. Double check your wiring and report back.
Terry
pss Looks like you've got a short where the .01 is connected to the terminal strip.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Parts list or Volume Pot Value - by JGatewood - 12-27-2010, 11:11 AM
Re: Parts list or Volume Pot Value - by 7estatdef - 12-27-2010, 12:15 PM
Re: Parts list or Volume Pot Value - by 7estatdef - 12-28-2010, 07:29 PM
Re: Parts list or Volume Pot Value - by JGatewood - 01-08-2011, 11:03 AM
Re: Parts list or Volume Pot Value - by 7estatdef - 01-09-2011, 07:02 AM
Re: Parts list or Volume Pot Value - by JGatewood - 01-09-2011, 10:50 PM
Re: Parts list or Volume Pot Value - by 7estatdef - 01-10-2011, 04:48 AM
Re: Parts list or Volume Pot Value - by JGatewood - 01-10-2011, 07:04 AM
Re: Parts list or Volume Pot Value - by JGatewood - 01-10-2011, 07:12 AM
Re: Parts list or Volume Pot Value - by JGatewood - 01-13-2011, 07:02 AM
Re: Parts list or Volume Pot Value - by 7estatdef - 01-13-2011, 06:06 PM
Re: Parts list or Volume Pot Value - by JGatewood - 01-14-2011, 07:21 AM
Re: Parts list or Volume Pot Value - by 7estatdef - 01-14-2011, 06:44 PM
Re: Parts list or Volume Pot Value - by JGatewood - 01-30-2011, 03:10 PM
Re: Parts list or Volume Pot Value - by 7estatdef - 01-30-2011, 04:16 PM
Re: Parts list or Volume Pot Value - by JGatewood - 01-30-2011, 05:20 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
American Bosch Model 802 auto radio
Hello again;   I found a model 838 car radio on Nostalgia Air under United American Bosch, http://www.nostalgiaair.org/...Arran — 09:32 PM
New Philco Repair Bench
Morzh is correct. The repair bench on our website is an archived image of chuck’s original site. He no longer provides s...klondike98 — 05:32 PM
Made mistake & did not label connection
Excellent information. It is all starting to come together now and your explanation really helped since I noticed that ...georgetownjohn — 04:39 PM
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together, go...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM

[-]
Who's Online
There are currently 5863 online users. [Complete List]
» 3 Member(s) | 5860 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration