Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Schematic Source
#1

I started to post this in the thread that Jake Wells was asking for a better schematic for his GE radio, but then I thought it'd be better starting a new thread for anyone not aware of the following site.

Here is a resource for anyone looking for a schematic.  Nostalgia Air is to be commended for serving the collecting community for years, but many of their scans are hard to read and have not yet been updated. The following site has great scans of both the Beitman manuals and the Rider manuals.  Beitman doesn't cover near as many sets but sometimes their schematics are cleaner than Riders.

There is a complete 1926 to 1966 Beitman index but each volume has an index in the front of the schematics it contains.  For anyone looking for a good schematic I would look at this resource, especially if your Nostalgia Air schematic is hard to read.  Note that some of the schematics provided to Rider were very poor to begin with so sometimes you're stuck with a hard to read schematic.  The manuals and indexes can be downloaded:

Beitman:

https://www.americanradiohistory.com/Beitman-Manual.htm

Rider:

https://www.americanradiohistory.com/Rider-Manual.htm

RCA Service Notes:

https://www.americanradiohistory.com/RCA...ervice.htm

I included the RCA "Red books" that have a wealth of info if you're working on an RCA set.  There is also a library of all kinds of publications like Radio Retailing (my favorite source for ads) and almost all of the Antique Radio Classified issues are on this site.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
Schematic Source - by Eliot Ness - 12-04-2019, 09:59 AM
RE: Schematic Source - by jake wells - 12-04-2019, 11:47 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 2477 online users. [Complete List]
» 3 Member(s) | 2474 Guest(s)
AvatarAvatarAvatar

>