Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-608 code 122 Capacitor Questions
#18

Look like the negative of the red is going between the 28 and 26 ohm candohm and the blue is tied to the 780 ohm? which is before the 268 ohm but the schematic is too blurry.
But yes the the both negatives are going to yellow but must be wired correctly per the schematic.


Messages In This Thread
41-608 code 122 Capacitor Questions - by rdaskew - 09-24-2018, 09:29 AM
RE: 41-608 code 122 Capacitor Questions - by sam - 09-25-2018, 01:47 PM
RE: 41-608 code 122 Capacitor Questions - by jake wells - 12-04-2019, 07:53 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 70 antenna lead
Jim If you mean the wire going from the Volume pot to the back, here It does not seem to run ovefr those. Quite t...morzh — 02:21 PM
Philco 70 antenna lead
Seems odd to me that Philco would run the antenna lead over top of the filter caps and the power cord. Would that not in...Jim Dutridge — 01:54 PM
Custom Hammond Power Transformer
Joseph, Very well done! Because the radio has some chassis corrosion, do solder or re-solder all chassis connecti...Chas — 12:50 PM
Philco 60 restoration
Arran The control is original. The wiper is some sort of round brass plate, that probably just digs into the carbon e...morzh — 12:28 PM
Model 41-280 5 dials
Have fun. This is my thread on that same radio. Bought in 2014, restored in 2017. Be prepared to deal with rubb...morzh — 12:24 PM
My first Philco radio.
Boy this party ready DIEDOldie Goldie — 12:01 PM
Model 41-280 5 dials
Welcome to the Phorum, blake3801! The right four knobs are correct for this set. The fifth knob on the left is an add-...GarySP — 10:34 AM
Model 41-280 5 dials
Hey everyone, new to the classic radio game. I’m being gifted a Model 41-280 from the in-laws, and from what I’ve seen o...blake3801 — 01:40 AM
Philco 60 restoration
Mike; So if you check the resistance from end to end the volume pot reads 3 meg Ohm? I could see 1 meg maybe, if some...Arran — 11:59 PM
40-180 electrical troubleshooting
I isolated the circuit. And I’m still blowing 60 resistor. I just ordered the 84 rectifier tube. To see if that’s the is...winamp920@yahoo.com — 10:58 PM

[-]
Who's Online
There are currently no members online.

>