Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Found: 38-690 Volume Control
#4

According to the service info the original part is 33-5240.

There's a previous discussion of that part here:
https://philcoradio.com/phorum/showthread.php?tid=13625

Quote:Part #75 is 500K and part #76 is 100K, for the dual pot.

No mention of the taper type but I'd bet on audio taper too (it is a volume control after all).


Messages In This Thread
Found: 38-690 Volume Control - by tbone - 12-27-2019, 08:31 AM
RE: 38-690 Volume Control - by Radioroslyn - 12-27-2019, 10:22 AM
RE: 38-690 Volume Control - by tbone - 12-27-2019, 12:58 PM
RE: 38-690 Volume Control - by Nathan Slingerland - 12-27-2019, 03:06 PM
RE: 38-690 Volume Control - by tbone - 12-27-2019, 03:40 PM
RE: Found: 38-690 Volume Control - by tbone - 12-28-2019, 07:04 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5006 online users. [Complete List]
» 1 Member(s) | 5005 Guest(s)
Avatar

>